Description
Single component anticorrosion alkyd-urethane-based primer-enamel (DTM).
Scope and specifics of application
Primer enamel ALURON is a non-pre-priming material with good decorative and anti-corrosion properties to protect metal, concrete and reinforced concrete surfaces with high requirements for open time, multipurpose application and service life in industrial conditions.
Used for corrosion protection of the inner and outer surfaces of various vehicles (agricultural machinery, construction equipment, public transport, rail transport) as well as to protect bearing and enclosing structures of buildings, bridges, pipelines, various pipes, antenna-mast structures, industrial buildings frameworks, community centers, shopping malls, spans of bridges, etc. ALURON primer-enamel is used as repair coating as well as finishing products after assembly both indoor and outdoor.
Information on material resistance to different environments is available upon request.
Main fields of application: power engineering, mechanical engineering, railway transport facilities, transport construction..Instruction for use
Metal surface should be abrasive blasted to grade 1 or 2 to GOST 9.402 (Sa 2,5) or Sa 2 to ISO 8501-1:2007). Clean surface must be free from dust and grease.If the quality of surface preparation decreases, the service life and its operating performance may change.
Conditions
Basis temperature higher than dew point no less than 3°C.
Ambient temperature from +5°С to +30°C.
Relative air humidity no more 80%.
The process of applying
|
Preparation |
Ready to use. Stir thoroughly before use with mixer. Thin if needed with formula thinner RP-1K, RP-1K F. |
|
Air-free spraying |
Thinning: 0-20% The diameter of the nozzle: 0,015-0,017" Initial pressure: 120-160 ATM |
| Air spraying |
Operational viscosity:25-60 s Thinning: 10-30% Nozzle diameter:1,8-2,5 mm Initial pressure: 3,0-4,0 atm |
|
Cross linking at 200С |
30 min - 5 hours. One layer coating is recommended. Inobservance of re-coating mode can cause paint damage. |
|
Roller Brush |
Can be recommended for small and hard-to-reach areas. Thin the primer-enamel depending on the working conditions when using brush. |
|
Thinner |
Formula thinner RP-1K, RP-1K F. |
|
Cleaner |
Formula thinner RP-1K, RP-1K F, thinners of types Р4, Р5, methyl benzene, dimethyl benzene. |
|
Finishing |
Tubing, pistol and other spraying tools must be cleaned after using. |
|
Cleaning |
Wash the tools after using immediately. The frequency of washing depends on the amount of sprayed material, the temperature and the time since the shutdown, including any time lag. |