Description
Single component anti-corrosion alkyd-urethane-based primer-enamel direct to metal.
Scope and specifics of application
ALURON UR primer enamel is used to protect metal surfaces exposed to weather conditions and increased abrasion. It is convenient to use in industries where the technological process of painting does not require rapid drying, but the treated surfaces are required to be abrasion resistant and durable.
It is used for vehicles internal and external surfaces decorative finishing: agricultural machinery, construction equipment, railway transport (all types of rolling stock), public transport (buses, trolleybuses, trams, etc.) as well as various transport metal structures and metal products being exposed to increased mechanical stress. It is recommended for painting agricultural machinery, machine tools, process equipment, metal supports.
Information on the material resistance to various media is available on request.
Main fields of application: power enginering, mechanical engineering, railway transport facilities, transport construction..Instruction for use
Metal surface should be abrasive blasted to grade 1 or 2 to GOST 9.402 (Sa 2,5) or Sa 2 to ISO 8501-1:2007). Clean surface must be free from dust and grease.
If the quality of surface preparation decreases, the service life and its operating performance may change.Conditions
Basis temperature higher than dew point no less than 3°C.Ambient temperature from +5°С to +35°C.
Relative air humidity no more 80%.
The process of applying
| Preparation |
Ready to use. Stir thoroughly before use with mixer. Thin if needed with formula thinner RP-1K, RP-1K F. |
|
Air-free spraying |
Thinning: 0-10% Nozzle diameter: 0,011-0,017" Initial pressure: 120-160 atm |
|
Air spraying |
Operational viscosity:25-60 s Thinning: 10-30% Nozzle diameter:1,8-2,5 mm Initial pressure: 3,0-4,0 atm |
|
Cross linking at 200С |
60-120 min. |
|
Roller Brush |
Can be recommended for small and hard-to-reach areas. Thin the primer-enamel depending on the working conditions when using brush. |
|
Thinner |
Formula thinner RP-1K, RP-1K F |
|
Cleaner |
Formula thinner RP-1K, RP-1K F, thinners of types Р4, Р5 |
|
Finishing |
Tubing, pistol and other spraying tools must be cleaned after using. |
|
Cleaning |
Wash the tools after using immediately. The frequency of washing depends on the amount of sprayed material, the temperature and the time since the shutdown, including any time lag. |